The pulse bag filter is a new high-efficiency pulse bag filter based on the bag filter. In order to further improve the pulse bag type dust collector, the modified pulse bag type dust remover has the advantages of high purification efficiency, large gas processing capacity, stable performance, convenient operation, long life of the filter bag, and small maintenance workload.
The operation procedure of the pulse bag filter is as follows:
(1) Close the power switch on the local operation, the power indicator light is on, switch the local remote switch to the local position (ie, turn the switch to the left), press the fan start button, the fan starts running, observe whether the fan is turning correctly, wait After the fan is turned to normal, it can be put into normal dust removal work. If it needs to be cleaned and ashed after a period of time (such as clearing the air before opening the air compressor with air compressor), press “cleaning start” button, pulse valve Open the cleaning ash separately, the screw machine and the ash discharging valve also work at the same time. If you need to finish the cleaning work, press the “cleaning stop” button. If the dust removal work is finally stopped, press the “fan stop” button.
(2) Remote control will switch the local remote switch to the programmed position (ie, turn the switch to the right), the remote start unit will send the short dry contact HJ, and the fan will run (such as with air compressor and air compressor running at the same time). As long as the fan is turned correctly, it can be put into normal dust removal. At this time, the timing cleaning control is implemented, that is, the dust removal operation is performed for a period of time (about 1~2 hours adjustable), the cleaning control is automatically input, and the screw machine and the ash discharge valve are automatically input after the input. Work (approx. 2 minutes adjustable), after working for a period of time, automatically stop cleaning, and then enter the next automatic dust removal, cleaning, and ash discharge cycle, until the remote stop unit short dry contact TJ is delivered, the unit stops.
(3) Notes:
1. The dust collector unit realizes online cleaning control;
2. The time interval between the unit timing cleaning and the online cleaning time is automatically executed by the time relay (adjustable);
3, before cleaning, pay attention to open the air compressor and equipment air bag valve, there must be gas source and pressure.
In addition to the correct operation of the above operating procedures, but also pay attention to the following maintenance methods, in order to better use the pulse bag filter:
1. Determine the regular ash maintenance time according to the dust quantity of the dust collector.
2. Determine the regular discharge of water according to the water accumulation in the air air bag.
3. Always check whether the dust cleaning system of the dust collector is working normally. If it is not normal, focus on checking the diaphragm valve loss, whether the electromagnetic pulse valve is malfunctioning, and replace it in time. The filter bag should be cleaned in time and replaced regularly.
4. Check whether the equipment is running normally according to fluctuations in equipment resistance.
5. Always check the use of consumables according to the list of consumables.
6. Regularly add grease to the lubrication parts of the equipment. The reducer is changed once every six months, and the lubrication points of the bearings are replenished once a week.
7. Pay attention to check whether the sealing degree of the electric control box is intact, prevent the water from entering the dust, and often clean the dust inside the electric control box.

Hand soap liquid

Hand Soap Liquid,Hand Foam Soap,Wash Hand Soap,Soap Hand Wash

Wuxi Keni Daily Cosmetics Co.,Ltd , https://www.kenidailycosmetics.com