The small pelletizer is mainly used for the pellet production of Chinese herbal medicine. We have already introduced it in the above. In this article, we will introduce the common fault analysis of the pelleting machine during use. There will always be problems during the operation of the machine, and the pelleting machine is no exception. Here's a look at the causes and troubleshooting of common faults in pelleting machines. When operating these release methods, it is important to note that the power supply must be turned off to perform the above-described shotgun failure recovery method. Best Neck Massager,Shiatsu Neck Massager,Neck Relax Massager,Best Massage For Neck Pain Shenzhen Jie Zhong Lian Investment Co., Ltd. , https://www.szmeizons.com Small pelleting machine introduction
1. When the pelleting machine is working, the motor stops suddenly. Reason: 1. Capacitance is broken. 2. The gear is stuck. Lifting method: Check the gear groove for any debris and clean the area. 2. When the pelletizing machine is working, the shaft cutter has a slight jump. Cause: The loosening of the compression block screw is as follows: Open the upper cover and tighten the 6 hexagon socket screws evenly.
Third, the pelleting machine generates abnormal noise during the operation. Reasons: 1. The shaft knife and the friction part of the machine body are dry and oil-free; 2. There is no oil between the gears. Lifting method: 1. Inject a few drops of clean cooking oil into the oil eye; 2. Apply a small amount of butter to each gear groove.
4. After the pelleting machine is energized, the motor does not run. Cause: 1. The power cord is not in good contact or the power plug is loose. 2. The switch is in poor contact. The lifting method: 1. Repair the power supply or exchange the same specification plug; 2. Repair or replace the same specification switch.
5. The heater fails to heat up. Cause: The plug is loose or the power cord is off; the lifting method: replace the same specification plug or repair the power socket. 6. When the pelletizing mechanism is used, the shaft knife rotates or the medicine surface sticks. Cause: The output stop lever is loose and there is a distance from the bottom of the shaft cutter. The pill cannot be scraped off the shaft slot. Lifting method: Adjust the distance between the discharge plate and the bottom of the shaft sipe, (about 0.1mm) and tighten the fixing screws. Master the problems and solutions that may be encountered during the operation of the pelletizer. If you encounter these problems, you can easily solve them. This will increase the production efficiency and efficiency.