Operating instructions for the use of the spiral pre-cooler

The spiral pre-cooler is suitable for pre-cooling equipment for slaughtering, cleansing chicken, duck and goose carcass. Today we will give you a detailed introduction to the working principle of the spiral pre-cooler. The working principle is that the bird enters the spiral pre-cooler from the inlet. The propeller blade pushes the poultry body to the exit and then pulls it out by the discharge plate. During the whole process, the fan always works, and the wind is blown by the trachea at the bottom of the casing to make the temperature of the coolant uniform, and the epidermis and internal tissues of the bird are both It is cleaned and cooled.

For the operation of the spiral pre-cooler, I believe that many customers are not very familiar with it. The operation and maintenance of the screw pre-cooler is a necessary condition to ensure the normal operation of the equipment and prolong the service life. If it is used improperly, the equipment is damaged and cannot be used normally. The accident causes accidents. Therefore, the maintenance and safe operation of the spiral pre-cooler and the selection and use of the equipment are equally important. I will introduce the operation instructions of the spiral pre-cooler.

1. The labor protection articles must be properly worn during the inspection. Be careful and careful.

2. The equipment should be inspected thoroughly before starting the machine. The spiral pre-cooling machine is not allowed to stand on the top. The spiral pre-cooling machine does not allow any objects such as linen and wooden irons.

3. Before the central control is turned on, the post personnel must be notified to confirm that the site is allowed to be turned on before starting.

4. The post personnel should always check the lubrication point and the temperature and running sound of the motor and reducer.

5. When the spiral pre-cooler malfunctions and overloads, the post must be notified to the central control before the treatment, and go to the electrical maintenance personnel to go through the power outage procedure, hang the sign, and then turn the key switch next to the machine to the non-control Location, clearing and maintenance do not allow the foot to stand in the screw pre-cooler.

6. After handling the equipment, you must carefully check the site to avoid dropping the tools into the equipment.

Everyone must follow the rules to avoid unnecessary trouble!