The oyster mushrooms cultivated in the bacteria bag will have a greatly reduced yield after the 2-3 mushrooms are produced, and if the temperature is raised, the quality will be lowered. How to cultivate a post-early mushroom that is equal or even higher than the yield of the former mushroom? The following is a simple and practical method - the method of breaking. Remove the bag of 2-3 mushrooms from the plastic bag, then scrape the old skin on the surface and soak it in 5% lime water. If the cartridge is dry, soak it in 1% saline for half a minute. Before soaking, make a through hole in the fungus tube to facilitate the salt water immersion, which will increase the yield. The fungus tube is cut into two sections from the middle, and the section is discharged upward into the trampoline or shallow groove. The section should be as flat as possible, the overall height should be 1-2 cm higher than the ground, and measures such as ridges should be taken around to prevent large water from entering. The gap between the broken tubes is filled with the debris of the bacteria and then filled. The section is covered with soil debris and grass ash, and the ratio is 1:1:2, and the thickness is about 1 cm. Spray a little water to wet and gently flatten it. The top layer is covered with a layer of microbial debris, which is about 1 cm thick. It is flattened after spraying a little water. It is necessary to use the mushroom pieces which are rarely found in the mushrooms to form crumbs. After maintaining the humidity for 4-5 days, spray the water again, and then manage it to the mushroom after the routine, which can increase the yield by more than l times. Disclaimer: Some articles on this website are transferred from the Internet. If legal rights of third parties are involved, please inform this website. phone Leading Laser Measure Module Factory in China
Product Specifications:
Accuracy
±1
mm (0.04 inch)
Measuring
Unit
meter/inch/feet
Measuring
Range (without Reflection)
0.03-150m
Measuring
Time
0.1~3
seconds
Laser
Class
Class
II
Laser
Type
635nm,
<1mW
Size
45*25*12mm
(±1 mm)
Weight
About
10g
Voltage
DC2.0~3.3V
Electrical
Level
TTL/CMOS
Frequency
10Hz
Operating
Temperature
0-40 ℃ (32-104 ℉ )
Storage
Temperature
-25~60 ℃ (-13~140 ℉)
Range Sensor,Laser Distance Module,Distance Sensor,Laser Measure Sensor Chengdu JRT Meter Technology Co., Ltd , https://www.jrt-measure.com
The World's First single transmitting single receiving design laser module, which has a big help to reduce producing cost and power consumption of the laser distance sensor.
This Laser distance sensor has high Accuracy up to ±1 mm, working as phase measure, which support RS232/RS422/RS485/Arduino to TTL communication.
This laser distance module is widely used in the Laser Distance Meter industry, also a very good choice for the Industrial applications. Most of measuring tools manufactures is purchasing from us in China.