Berberine Hydrochloride Tablets Berberine Hydrochloride Tablets,Berberine Hydrochloride Tablet,Intestinal Infection Diarrhea,Treatment Of Intestinal Infection SHANDONG XINHUA PHARMACEUTICAL Co., Ltd. , https://www.sdxinhuapharm.com
If it is not turned into a sticking head when the machine is turned on, the temperature of the die is too high, and it can be normal after a little cooling. Under normal circumstances, there is no need to stop.
2) The water temperature should generally be 50---60°C, which is easy to break the strip, and it is easy to stick. When the initial start-up, Zui adds half of the hot water. If there is no condition, the pellet can be transported to the pelletizer for a period of time. After the water temperature rises, let it automatically pelletize to avoid broken strips. After the water temperature exceeds 60 °C, it is necessary to add cold water to the inner circulation to maintain the temperature.
3) When granulating, be sure to pull the strips before entering the rolls, otherwise the granulator will be damaged. If the vent hole is out of the competition, it proves that the impurity has blocked the filter. At this time, the mesh should be replaced by a quick stop. The mesh can be used with 40---60 mesh.
Start-up operation method 1. Before starting the machine, first warm up for about forty-five minutes. Raise the temperature to the motorized V-belt until it is free; pull it continuously eight to ten times according to the normal working direction. Then continue to heat up for about ten minutes, and then start up, but continue to warm, because normal production needs to continue to replenish heat; adjust the temperature according to different properties of plastic.
2. When the granulator is working normally, the machine temperature should be stable and should not be high or low. Near the vent hole, until the temperature of the head is about 200 °C (refer to propylene, B).
3, the feed should be even, and add enough. The feeding speed of the machine and the feeding speed should be appropriate. Otherwise it will affect the quality and yield of the particles.
4. When the machine is shut down, the host should completely cut off the power. The head plug (with wrench part) must be removed. Warm up separately before the next use.
1) When the operator fills, be sure to look good, do not enter the material in the material, master the temperature.