1, sowing Seeds before seeding are soaked with 25-30 degrees of warm water for 12-16 hours. After being removed, the seeds are germinated with wet soil in the shed. The upper and lower covers of the seeds are 1.5 cm thick. When the seed buds are about 1.5 cm long, they are planted 2 cm deep in the nutrient seedling bed, or broadcast live in the shed, seeding 2 seeds per hole, and then covering the plastic film with a low arch shed. 20-30 days after sowing, when the seedlings are unfolded, when the raw leaves and the first compound leaves are born, they can be transplanted or colonized. 2, seeding seedlings should pay attention to the problem Be sure to pour the seedbed water before sowing. Do not pour the Mengtou water after sowing. Do not sow too deep or too shallow. It is better to use 1.5-2.0 cm to master the temperature of the seedbed. In order to maintain 20-26 degrees during the day, 16-18 degrees at night is appropriate, 7-9 days after sowing can be emerged. The above is the introduction of the seedling technology of lentil planting in the shed. I hope that the Hui Nong School can help everyone.
Joist Tape Deck Flashing Tape Butyl Joist Tape for Decking
The Joist Tape is a malleable polyethylene waterproof wood flashing and material, using a rubberized asphalt mastic adhesive. Rot is caused by moisture that stays in contact with treated and untreated lumber deck framing and the above decking material. Wood decay can also occur when deck screws penetrate the deck boards, piercing the joist sub-framing below. The deck joist tape is easily apply to decking joists, around deck support posts and over ledger boards, which creates a waterproof seal that helps stop decay and wood rot.
The joist tape for decking as a barrier, it can reduce moisture damage to crossbeams. The joist butyl tape is used in temperatures range of -20°F to 176°F, it protects and maximizes the life of your new deck and creates a waterproof membrane that prevents wood rot caused by moisture.
Product Name
Material
high-density polyethylene (HDPE)
Adhesive
Pressure Sensitive
PE Film
White, other colors can be customized
Butyl Rubber
white, other colors can be customized
Application
How To Use The Joist Tape for Decking
The joist tape for decking is easy to install just in seconds. Clean the adherend surface, cut the appropriate length as needed, peel off the protected film, and carefully press the tape against target area. Mistakes are easily rectified within the first few minutes of installation.
Joist Tape,Deck Joist Tape,Joist Tape for Decking,Joist Tape for Decks,Butyl Joist Tape Kunshan Jieyudeng Intelligent Technology Co., Ltd. , https://www.yuhuanptapes.com
Butyl Joist Tape
Providing corrosion protection
